Inception Designs Beavertail for ID Frame

This low profile beavertail is designed to be as short as possible. It can be easily adjusted for length, can be locked down to prevent it slipping (without the use of loctite) and can be used for all full body (guns with back blocks) Autocockers and
Add to cart

Comes with a stainless steel shaft, angled rear section in polished black and stainless steel locking set screw.

If you need to further lengthen the beavertail in an Inception frame we recommend the use of our "Back Block and Mid Block locking screws" screw set available separately. Install the set screw of your choice into the frame first and then screw in the beavertail rod behind it.

0 review

0 stars based on 0 reviews